Product Description
LC2i - 2 Channel Line Out Converter with Accubass and Subwoofer Control
The AudioControl LC2i, is a compact, two-channel processor with active input circuitry, which allows it to accept speaker-level signals of up to 400 watts per channel from factory-installed source units or amplifiers. It converts them to high-quality pre-amp signals that can then be directed to after-market processors and/or amplifiers. Users can enjoy maximum sound quality while maintaining the use of factory volume and steering wheel controls.
The AudioControl LC2i is also a super low distortion (typically <.01%) 9.5-volt line driver as well as a line converter. You now have sound quality every bit as good as with an after market head unit while keeping the convenience and cosmetic features of the factory installed source unit. In short, the LC2i gives you the brilliant sound quality that AudioControl has been providing for over 33 years. Combine this with the AccuBASS equalization discussed below and you have mind-bending performance from a factory head unit.
Active, High Impedance Inputs
With AudioControl's Active, High Impedance Inputs you're in a whole different world. AudioControl's input stage results in a ruler-flat frequency response so you get rock solid bass without the signal roll-off you get with those passive LOCs. Passive LOCs have been used for years yet they add distortion, reduce signal and roll off bass. In short... they sound bad!
AccuBASS™ Bass Compensation
Most factory speaker systems are not capable of loud, clean bass reproduction. This is why many car manufacturers restrict bass frequencies at higher volumes. AudioControl's AccuBASS Bass Compensation circuit corrects this with a set it and forget it remix circuit.
General Features:
- Two channels of active speaker level inputs - Accepts 400 watt signals per channel
- AccuBASS processing for correction of bass roll-off
- Fixed and variable outputs with discrete level controls
- GTO - Signal sensing inputs
- 12-volt trigger that will turn on LC2i
- Dual amplifier
- 9.5 volt pre-amp outs
- Level matching controls
- 12 Volt trigger output
- Input for optional subwoofer level control: AudioControl ACR-1
- Dimensions: 6-3/8"W x 3-1/8"D x 1-1/2"H
- 5 Year Manufacturer's Warranty (*when installed by an authorized AudioControl dealer)
The LC2i Specifications
- Maximum speaker level input: 400 watts per channel
- Maximum Preamp output: 9.5Vrms / 13V peak
- Optional Dash Level Control Remote: +0dB / -19dB
- Frequency response: 10 Hz - 100,000 Hz; ±1dB
- Total harmonic distortion: 0.01%
- Signal to Noise ratio: >110dB
- Input Impedance: 20K ohms
- Output Impedance: 150 ohms
- Power draw: 150 mA
- Recommended fuse rating: 1 Amp
- Weight: 1 pound
